1) 2.0tdi engines in the early 2005 B7 A4 models ( and the A6 models )should just be avoided at all costs unless the balance shaft conversion has been completed. Even then the 2006 models have had injector issues and oil pump failures.
I have 2004 b6 A4 2.5 TDI new battery, on turn over no clicking, but clock and dash fine. Last time I had this on Audi A6 1994 it was starter motor fail. One thing I have learnt from 4 audis over last 20 years, wiring, electrics, sensors are definitely the weakest link in the chain.Audi S4 00-02 2.7T, Audi A6 Quattro 01-04 2.7T & 3.0, Audi FWD 02-05 3.0, A4 Quattro 02-05 3.0 To avoid problems, take one simple step: clean your MAF every 5-10
Common causes of a failed connection or thrown rod in an Audi 3.0 TDI engine. Hydro-locked engine, i.e., an engine filled with fluids rather than air. Thus, the connecting rods will bend if you start your vehicle under this condition.Audi A6 Quattro/ 33 850 лв. дата на произв. - октомври 2016 г., пробег - 219743 км, цвят - Графит, GERMANY AUTO Ви предлага Ауди А6 3, 0 TDI Quattro TEST Audi A6 Allroad 3.0 biTDI quattro – Nejlepší z rodu Avantů. Současná čtvrtá generace prošla nedávno faceliftem a my nyní máme k testu silnější variantu třílitrového jednoturbového naftového šestiválce, která posílila na 200 kW. To vše zabaleno do ocelově šedé karoserie sedan s doplňky S-line a krásnými
Hi, i have a 2005 2.0tdi, was showing empty and 35miles in tank, put 25quid worth of diesel in, when i started car needle didnt move and still showed 35miles left. Pump was definatly dispensing diesel so problem is with car.
According to carcomplaints.com, here are the Audi Allroad years to avoid: 2003 Audi Allroad. 2013 Audi Allroad. 2015 Audi Allroad. The worst fault with the Audi Allroad is engine problems. This is one of the most expensive components of a vehicle, and it can lead to the downfall of a car in no time.Step 2 – Remove all connections to fuel rail. To access the fuel rail, we have to remove all the parts connected to it. Looking at Figure 2, remove the electrical connection on the top left, then remove the electrical harness from the N80 valve, which is right next to the other connection. Remove all the hoses circled in green (you will have
kPONJe.